Brick Barbecue Photo

The basic design is easily expanded by adding additional blintus walls to which new working surfaces can be located. And a little of the walls lifting the wood or stove can be arranged, so people can be located in the immediate vicinity of the cooking site.

Barbecue sweet

Before the barbecue, prepare the ribbon base using the boards and markers. Pull the shoelaces so as to mark the position of the future barbecue wall, and put a layer of solution on a prepared ribbon base along one of the walls. When you've done the slobs on the slob, start the barbecue with the 1st brick. Check his horizontalness at the same time.

Put the 2nd row on, starting it from the floor of the split brick cross to create a spoon. Keep laying the following rows, moving each of them to the calibre. On the 5th row, form a backbone.

Rhys. 2. Second Barbecue

On the top of a number of bricks, you will continue to lay the walls in half a fold, leaving three more. As a result, there is a narrow leap that can be precipitated by a heat bar and a charcoal pallet. If there is no pallet of sufficient width that would allow it to be placed in the wall, a metal shelf may be used to support the pan.

2nd gesture, sorrow the 10th near the bricks and add three more rows by spooning to finish the bulk of the barbecue.

If as a backbone, you want to use not bricks, but metal rods, don't do bricks, but keep bricks and between the 6th and 7th rows, put long steel rods in the stitches. The stems shall be approximately 75 mm from all three walls so that they can be fitted with a bar and a pallet.
Continue to lay the following bricks in the stacks of each row to obtain a set of different heights that can be fitted with a heat bar. Complete the construction on the 10th row of bricks.

Working surface

The simplest way of constructing a barbecue work surface is to build a low brick wall of a bladder of 6 bricks mounted on a single ribbon, parallel to one barbecue side wall. The bricks of the 6th row of the blintus wall put a pump.